Power setting - Leistungseinstellung mit J S 3
Brücke J S 3 Erzielbare Leistung
bei vollen Batterien
JS3 closed
default setting
500 mW High and 10
mW low power settings
as indicated before.
JS 3 geschlossen
Fabrikeinstellung
Das Gerät arbeitet mit
der üblichen
Sendeleistung Hi = 500
mW und Lo = 10 mW
JS 3 opened
JS3 geöffnet
LPD Band
HI power 3 Watt
LO power 0.500 W
JS 3 opened
JS 3 geöffnet
PMR Band
HI power 3 Watt
LO power 1.5 Watt
Legal Note: Only licensed amateur radio operators may use the above mentioned power
values in the LPD band only- for purpose of Amateur Radio.
Hinweis: Nur lizenzierte Funkamateure dürfen die genannte Sendeleistung im LPD Band
entsprechend Ihrer Amateurfunklizenz benutzen, jedoch nur für Amateurfunkzwecke!
Note: If You should find that closing the cabinet near to antenna position will be difficult,
please remove a little bit the plastic like the pictures below show.
BEFORE AFTER
©CTE and ALAN Electronics, 2005