Page 17
midlandusa.com
Model GXT67 Pro
MAKING A GROUP CALL
Group Call allows you to do a Group Call alert to only one Group, or all Groups
with the same Group Code.
• You must be in Group Mode for Group Call to function.
• Only radios set to the same Channel and Group Code will
receive your Group Call.
1. While in Group Mode, press the CALL / LOCK button.
2. Use the UP / DOWN arrow buttons to select a specific Group Number /
Group ID to receive your call, or select “ALL” Groups to receive the call.
3. Press CALL / LOCK again to send the Call to only the selected Group.
REPEATER OPERATION
The GXT67 Pro can access a national network of Repeaters that can extend the
range of the radio when using Repeater Channels 15 - 22. Repeater Channels
operate with different reception and transmission frequencies.
1. Select REPEATER from the Top Menu and press the MENU button.
2. Use Up / Down to select whether Repeater Channels will be available for
use (Enabled) or not available for use (Disabled).
3. When MENU is pressed with Repeaters ENABLED, a sub-menu for
configuring Repeater Channels is provided.
4. For each Repeater Channel (RPTR 15 through RPTR 22), separate
Receive (RX) and Transmit (TX) Privacy Codes may be selected. Select
the Repeater Channel you want to configure and press MENU, then select
Privacy Codes as described in the SETTING PRIVACY CODES section -
first for the RX Privacy Code, then for the TX Privacy Code.
• Repeaters are not compatible with Group Mode operation.
Repeater channels will not be available while using Group
Mode.
To Next Page
Loading...
Need help?
General
