microphone. When operating from a noisy
vehicle, reducing the Mic Gain setting will
usually improve your transmitted voice
clarity. Check with other operators to
détermine the exact setting best for your
voice and car.
CB/РА Switch. An optional PA speaker may
be attached to your transceiver through the
PA output jack on the back panel. This
allows you to communicate with
pedestrians or other vehicles through your
CB microphone. The CB/РА switch
changes your CB speaker system from a
CB function, using the internai main-unit
speaker, or optional external speaker, to a
Public Address function.
Dimmer Switch. Dims or brightens lighted
Controls for more comfortable day or mght
visibility.
Tone Switch. Controls the tonal quality of
received signais in accordance with the
user’s preference.
NB/ANLSwitch. In the NB (Noise
Blanker) & ANL (Automatic Noise Limiter)
setting, it reduces electrical impulse
noises, such as those caused by engine
ignition Systems, atmospheric noise and
other electrical interférence. The "Off”
setting is used when neither problem existe.
RF Attenuation Switch. Reduces the
incoming signal strength before reaching
the sensitive receiver circuits. Use the “on”
position to improve receiver cross-
modulation and blocking performance in
strong signal metropolitan and urban areas.
Dual red/green TX/RX Indicator. When red,
it indicates the unit is transmitting and acts
as a warning when the microphone push-
to-talk bar is accidentally keyed. When
green, it indicates your transceiver is in the
“receive” mode.
AWI (Antenna Warning Indicator). Alerts
you to trouble in your antenna system that
could damage your transceiver. When the
AWI light cornes on, you should stop
transmitting immediately.
External Speaker Jack. Allows you to
attach an external speaker that will override
the unit’s internai speaker. Connection is
made through the External Speaker Jack
on the back panel.
PA Jack. An optional PA speaker may be
attached to your transceiver through the PA
output jack on the back panel. This allows
you to communicate with pedestrians or
other vehicles through your CB
microphone.
Microphone Push-to-Talk Bar. Simply push
this bar to transmit; release when receiving.
13
To Next Page
Loading...
