How to install your
Midland mobile CB
This transceiver may be installée! in
any 12-volt negative or positive
ground-system car or truck. Most
current U S. and foreign vehicles use a
negative system, but some older
models and some newer large trucks
may hâve a positive ground.
Check the requirements for your
vehicle betöre you begin installation.
. Generally, you hâve a negative-
ground system if the minus (-) battery
terminal is connected to the motor
block. Contact your dealer in the event
you are unable to détermine your
vehicle’s polarity system,
Installation and operating
accessories furnished with
your Midland Mobile CB:
1. “Take-it-with-you” adjustable
mounting bracket system.
2. Microphone bracket system.
3. All main-unit and microphone
mounting hardware needed for
normal installation.
4. DC power cord with plug.
5. Plug-in microphone with coil cord.
6. FCC Form 505
7. FCC Part 95, Subpart D.
8. FCC Form 555-B.
9. Owner's Manual.
10. Customer Registration Card.
Where to locate your CB
transceiver.
Your new Midland CB is designed
to be installed under the dash of your
vehicle.
Safety and convenience are the
primary considérations in deciding
exactly where to locate your radio.
The transceiver is designed w ith
m ost-often-used Controls nearest the
driver. Still, make sure other Controls
are easily reached
Caution: Be sure that the unit is
located so that it does not interfère
with the driver or impair access to any
Controls. Connecting cables must be
routed and secured in such a manner
as to not interfère with the operation
of the brake, accelerator or other
Controls. Interférence from either the
unit or connecting cables may
contribute to the loss of control of the
vehicle.
7
To Next Page
Loading...
