Midland XT-10 - Technical Specifications; Device Specifications; Transmitter and Receiver Details; Power Supply Attention

XT10 instruction guide | 11
Technical specifications
Channels ..................................................16 PMR446 (8 + 8 pre-programmed)
Frequency ...........................................................446.00625 - 446.09375MHz
Channel spacing ......................................................................................... 12.5 KHz
Power supply............................................................. 3x AAA type 4.5V(Alkaline)
........................................................ 3.6V(Rechargeable) batteries +/- 10% VDC
Operating temperature ..................................................................... -20° to +55°
Dimensions (w/out antenna) ......................................................... 85x30x48mm
Weight (w/out batteries) .................................................................................... 73g
Duty cycle .............................................................. TX 5%, RX 5%, stand-by 90%
Category ..................................................................................................................B
Transmitter
Output power ...................................................................................500 mW ERP
Modulation ........................................................................................................... FM
Spuriuous rejection ............................................................within ETSI regulations
Receiver
Sensitiviy @ 12dB Sinad........................................................................... <0,30V
Adjacent channel rejection .............................................................................70dB
Audio output power ......................................................... .~150mW @ 10% THD
Intermediate frequencies ............................................ 1°:21,4 MHz ; 2°:455 KHz
Specifications are subject to change without notice.
ATTENTION
Direct plug-in ac/dc power supply must be used for disconnecting the transceiver
from the mains; the desktop charger must be positioned close to the unit and
easily accessible.