6 | XT50 PRO user’s manual
Let’s communicate!
To turn on/o the radio
Hold down MENU/ for 3 seconds.
Channel selection
Press once the Menu button and then select the desired channel by the ▲/▼
buttons. Press PTT to confirm the selection. Remember that both radios must
be set on the same channel.
Transmission
Keep pressed the PTT button. The display will show “Tx” and “to”. Release the
PTT and the radio beeps to confirm to other users that your transmission has
finished ( ‘Roger Beep’, see paragraph).
Reception
Simply release the PTT button. When you receive a signal “Rx” is displayed.
Volume adjustment
Press the ▲/▼ to adjust the volume at the desired level.
button
This feature is very useful to avoid accidental pressure of the buttons. Press and
hold the “
/CALL” button for more than 3 seconds. The icon confirms that
the keypad lock is activated. Only PTT and
/CALL will still be active. Repeat
the same procedure to unlock the keypad.
Menu button
The following functions can be selected by pressing the Menu button:
• VOX
• Roger Beep on/o
• Channel setting
• CTCSS/DCS tone setting
• Keypad Beep
• High/low power selection (PMR band)
• Tone selection for the CALL feature
To Next Page
Loading...
