Midmark 222 - User Manual

003-2557-00 Rev. A (11/20/12)
003-2557-00 Rev. A (11/20/12)
Exam Table Lift Device
(For use with models
222, 223, 622, 623, & 625)
Exam Table Lift Device
(For use with models
222, 223, 622, 623, & 625)
Step 2: Lay Exam Table Lift Device flat
on metal crossbar.
Step 3:
A) Press Base Up on hand control
to raise table height.
B) Insert legs into spline receptacles.
Step 4: Press Base Down on hand control
to lift the table base to desired height.
Caution
Ensure Lift Device is secure before
lifting table. Do not use if table is
damaged or table lift is damaged.
Step 1:
A) Lift seat section.
B) Hook Exam Table Lift Device
onto hinge lip.
Step 1:
A) Lift seat section.
B) Hook Exam Table Lift Device
onto hinge lip.
Step 3:
A) Press Base Up on hand control
to raise table height.
B) Insert legs into spline receptacles.
Step 2: Lay Exam Table Lift Device flat
on metal crossbar.
Step 4: Press Base Down on hand control
to lift the table base to desired height.
Caution
Ensure Lift Device is secure before
lifting table. Do not use if table is
damaged or table lift is damaged.

Midmark 222 Specifications

General

Brand	Midmark
Model	222
Category	Lifting Systems
Language	English

Summary

Exam Table Lift Device Installation and Use

Step 1: Attaching the Lift Device

Lift seat section and hook device onto hinge lip for secure attachment.

Step 2: Positioning on Crossbar

Lay the lift device flat on the metal crossbar before proceeding.

Step 3: Raising Table and Inserting Legs

Use hand control to raise table height and insert legs into spline receptacles.

Step 4: Lowering Table Base

Press hand control to lower table base to the desired height.

Critical Safety Warning

Ensure lift device is secure before lifting; do not use if damaged.

Procedure Table Lift Device Installation and Use

Step 1: Positioning Behind Actuator Shaft

Press tilt up, place device behind actuator shaft, then press tilt down.

Step 2: Raising Table and Inserting Legs

Use hand control to raise table height and insert legs into spline receptacles.

Step 3: Lowering Table Base

Press hand control to lower table base to the desired height.

Critical Safety Warning

Ensure lift device is secure before lifting; do not use if damaged.