Installation Options
Preva
2
Articulating Arm
The Articulating Arm provides the articulation support for the Tubehead and the
reach and coverage of the Tubehead to the patient.
Horizontal Arm
The Horizontal Arm helps provide the necessary reach for the VetPro
®
DC. It
pivots around a shaft inserted in the top of the Control Unit and contains an access
cover to connect the cable from the Horizontal Arm to the Control Unit. It is
available in four lengths on wall mount units providing reaches of 56, 66, 76 and 82
inches [142, 167, 193, 208 cm].
Modular Beam
Limiting Device
[BLD]
The cone establishes the distance from the X-ray tube to the patient’s skin. It
provides positioning assistance and collimates the X-ray beam.
Remote Control
The remote control switch is used to make exposures in addition to or replacing the
use of the exposure button.
Model
Configurations
Installation and
Service
The Preva is available as both a wall mount and mobile unit. See Appendix A for
the installation instructions for the mobile unit.
The Preva Dental X-ray System should only be installed and serviced by approved
Midmark dealer personnel. Contact Midmark Corporation at 800-MIDMARK if you
need assistance locating an approved dealer.
Copyright and
Patents
© Midmark Corporation 2014
U.S. Patents D470237, D469182, D470589, and 6,837,468
To Next Page
Loading...
