Need help?Do you have a question about the Midmark VetPro and is the answer not in the manual?
Specifies the intended use of the VetPro DC X-ray system in dental radiography.
Lists any known conditions or situations where the system should not be used.
Details the components and features of the VetPro DC X-ray system.
Provides critical safety information regarding installation and load bearing for safe, permanent installations.
Outlines safety procedures and distances to ensure operator and patient safety from X-ray radiation.
Defines the duties and verification requirements for installation and service personnel.
Details the different reach options available for the horizontal arm of the system.
Lists the standards the system complies with regarding radiation performance and safety.
Lists the regulatory documents and standards to which conformity is declared.
Specifies environmental conditions for indoor use, temperature, humidity, and altitude limits.
Defines wall support requirements, load capacities, and acceptable mounting materials.
Details mains power supply, line cord suitability, voltage, fuse rating, and line resistance requirements.
Instructions for safe operation concerning radiation exposure for operators and patients.
Guidelines for safe electrical installation and operation, including grounding and GFCI usage.
Precautions regarding flammable or explosive gases and vapors.
Guidance on compliant and safe disposal of electrical and electronic equipment.
Provides contact details for Midmark, technical library, and support services.
Describes three mounting configurations for installing the VetPro DC system.
Instructions for mounting the Control Unit on a single wood stud, solid wall, or reinforced wood cabinet.
Instructions for mounting the Control Unit on two wood studs using a wall plate.
Instructions for mounting the Control Unit on a metal stud wall using a support plate.
Details the installation procedure for the 4x4 mount kit.
Describes attaching the Operator Panel directly to the Control Unit.
Explains mounting the Operator Panel remotely on a wall, including cable routing.
Covers pre-installation checks, tools needed, installation time, and opening the shipping carton.
Guides on locating and marking holes for control unit mounting using a template.
Steps for safely removing the front cover of the control unit.
Instructions for attaching and leveling the control unit to the wall mount.
Details mounting the control unit to a wall plate installed on dual wood studs.
Instructions for mounting the control unit to a metal stud wall assembly.
Procedure for mounting the VetPro DC to a Midmark Chase unit.
Steps for installing the horizontal arm and its associated brake assembly.
Procedure for attaching the articulating arm and tubehead assembly to the system.
Instructions for installing and adjusting the articulating arm brake assembly.
Details how to connect the various cables between system components.
Steps to connect the horizontal arm cables to the internal circuit boards.
Instructions for connecting the system's power via a permanent hardwired connection.
Instructions for connecting the system's power using a detachable power cord.
Details how to connect the operator panel using a 25-foot cable.
Information on when calibration is needed and how to proceed.
Steps to verify input voltage and power on the system for the first time.
Procedures to check the status of the system's circuit boards using LEDs.
Instructions for adjusting the horizontal arm's braking mechanism for smooth movement.
Detailed steps for adjusting the friction assembly screws on the arm.
Procedure to adjust the articulating arm's stopping point to prevent contact with the horizontal arm.
Adjusting the vertical movement of the articulating arm to prevent drifting.
Adjusting the balance of the articulating arm so the control unit side doesn't drop.
Adjusting friction points on the articulating arm for desired positioning force.
Lists the necessary tools for assembling the mobile unit.
Lists the tools needed for replacing the power cord of the control unit.
General| Brand | Midmark |
|---|---|
| Model | VetPro |
| Category | Medical Equipment |
| Language | English |
To Next Page