Need help?Do you have a question about the Midtronics MSP-070C and is the answer not in the manual?
General| Input Voltage | 120V AC |
|---|---|
| Input Frequency | 60 Hz |
| Output Voltage | 12V DC |
| Charging Algorithm | Multi-stage charging (Bulk, Absorption, Float) |
| Battery Type | Lead-acid |
| Battery Compatibility | 12V batteries |
| Charging Modes | Standard, AGM, Gel |
| Output Current | 7 Amps |
Batteries generate explosive gases during operation, discharge, or charging, posing an explosion risk.
Charging non-rechargeable batteries may cause them to burst, leading to personal injury and damage.
Keep water and soap nearby for acid contact; flush eyes immediately with cold water for 10 minutes.
Wear eye protection, rubber-soled shoes, and avoid sparks or flames near batteries.
Remove metal jewelry like rings and bracelets to prevent severe burns from short circuits.
Charger must be grounded to reduce electric shock risk; use a properly installed grounding plug.
Ensure best possible mechanical and electrical connection with clamps for safety and efficiency.
Switches may not fully disconnect circuit; always unplug from AC outlet when idle.
To Next Page
