~
The lab washer is only designed to
operate with water and the appropriate
processing chemicals. The machine
must NOT be operated with organic
solvents or flammable liquids. This may
cause an explosion or damage to
rubber and plastic components, which
in turn allows liquid substances to leak
out.
~
The water in the machine must not
be used as drinking water.
~
Do not sit or lean on an open door.
The machine could tip and be
damaged or cause injury.
~
Be careful when sorting items with
sharp pointed ends. Position them in
the machine so that you do not hurt
yourself or create a danger for others.
~
When using this machine regard the
high temperatures and be especially
careful not to scald or burn yourself.
When opening the door bypassing the
electrical lock, a danger of burning,
scalding and corrosion exist. Let mobile
units, inserts and cleaned items cool
before touching them. Any water which
may remain in containers will be very
hot and must be emptied into the wash
cabinet.
~
If toxic chemical substances can
form in the wash water during
processing (e.g. aldehydes in the
disinfection agent), the door seal and, if
applicable, the function of the steam
condenser must be checked regularly.
In this event, opening the door of the
lab washer during a program
interruption is particularly hazardous.
~
If you are exposed to toxic vapors or
processing chemicals, consult the
manufacturer's material safety data
sheets for emergency procedures.
~
Mobile units, baskets, inserts and
the load itself must be allowed to cool
before removal. The dispensing parts
should also be drained of any residual
water.
~
After drying with the drying unit,
open the door to allow the load, mobile
unit, baskets and inserts to cool down.
~
Do not touch the heating element if
you open the door at the end of the
program. You may suffer burns even
several minutes after the program has
ended.
~
Never clean the machine near or
with a water or high pressure hose.
~
Before servicing, disconnect the
power supply by either removing the
fuse, unplugging the unit or manually
"tripping" the circuit breaker.
,
Mount on non-combustible floors
only!
IMPORTANT SAFETY INSTRUCTIONS
5
To Next Page
Loading...
