If the quality of the milk froth is
unsatisfactory, the air intake hose may
be clogged. Follow the instructions in
"Step 2: Cleaning the air intake hose
and angled section in the door."
If no milk comes out of the main
dispenser, only steam, please follow
the instructions in Steps 1 to 3.
First check if the milk in the milk
container has spoiled. This can clog
the milk pipework.
To clean the clogged milk pipework,
take a step-by-step approach.
Afterwards, check if the preparation
and quality of the milk and/or milk froth
are satisfactory.
If the preparation and quality of the milk
and/or milk froth are still not
satisfactory, do not make any drinks
and repeat the steps described.
Step 1: Cleaning the milk
pipework in the lid of the milk
container
^ Pull the milk intake pipe a out of the
milk container lid.
Make sure you also remove the seal
b.
^ Clean both under running water.
Insert the supplied cleaning brush
into the stainless steel pipe and move
it back and forth until all milk residue
has been removed.
^
Use the cleaning brush to clean the
milk pipework in the lid as well.
Cleaning clogged milk pipework
74
To Next Page
Loading...
