EasyManuals Logo

Miele Complete C2 User Manual

Miele Complete C2
Go to English
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
en
42
A safety device prevents the lid clos-
ing without a dustbag in place. Do
not use force!
Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces (dia. 01).
When to change the motor protection
filter
Replace this filter every time you start a
new packet of dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain four motor protection
filters.
How to change the motor protection
filter (dia. 33)
Open the dust compartment lid.
Pull the dustbag out by the grip on
the collar.
Lift up the filter frame until it clicks
and remove the old filter. Hold by the
clean, unsoiled section to remove it.
Replace with a new motor protection
filter.
Close the filter frame.
Fit the dustbag into the holder as far
as it will go.
Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
When to replace the exhaust filter
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
12).
a AirClean
Replace this filter every time you start a
new packet of dustbags. Every packet
of original Miele dustbags contains one
AirClean exhaust filter. Multipacks con-
tain four AirClean filters.
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
Replace this filter when the exhaust fil-
ter timestrip indicator is completely red
(dia. 17). The indicator lights up after
approximately 50 hours of operation
which is equivalent to about a year of
average use. You can continue vacuum-
ing when the light comes on. However,
the suction power will be reduced as
will the effectiveness of the filter if it is
not replaced in good time.
How to replace the AirClean exhaust
filter (dia. 34 + 35)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Release the filter grille and raise it up-
wards as far as it will go.
Grasp the used AirClean filter by the
clean, unsoiled section and take it out
(see arrow).
Replace it with a new AirClean ex-
haust filter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele Complete C2 and is the answer not in the manual?

Miele Complete C2 Specifications

General IconGeneral
Power controlElectronic
Maximum input power800 W
Annual energy consumption30 kWh
TypeCylinder vacuum
Cleaning typeDry
Dust capacity4.5 L
Flexible hoseYes
Product colorRed
Tube materialStainless steel
Dust container typeDust bag
Proper useHome
Noise level77 dB
Cleaning surfacesCarpet, Hard floor
Vacuum air filteringMiele AirClean
Dirt separating methodFiltering
Cord length6.5 m
Vacuum brushes includedDusting brush
Weight and Dimensions IconWeight and Dimensions
Depth275 mm
Width590 mm
Height380 mm
Weight6000 g

Related product manuals