EasyManuals Logo

Miele Complete C2 User Manual

Miele Complete C2
Go to English
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
en
43
If you wish to fit an Active AirClean
50, AirClean Plus 50 or HEPA
AirClean 50 filter, see "Replacing one
type of exhaust filter with another".
Close the filter grille.
Close the dust compartment lid.
Replacing the Active AirClean 50,
AirClean Plus 50 and HEPA AirClean
50 exhaust filters (dia. 36 + 37)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Lift the exhaust filter and remove it.
Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
Press the exhaust filter timestrip in-
dicator (dia. 15).
After approx. 10 - 15 seconds a thin red
line will appear in the left hand side of
the display (dia. 16).
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 12)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b Active AirClean 50 (black)
c AirClean Plus 50 (light blue)
d HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter please note
1. If you wish to replace exhaust filter a
with filter b, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
You must also activate the exhaust
filter timestrip indicator (dia. 15).
2. If you wish to replace exhaust filter b,
c or d with filter a, it is essential that
you also fit the filter grille * (dia. 35).
* Filter grille - see "Optional ac-
cessories".
When to change the thread lifters
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.
How to replace the thread lifters
(dia. 38)
Use a suitable screwdriver to remove
the thread lifters from the slots.
Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 39)
Release the bearing (with bayonet fit-
ting) using a coin.
Press the bearing out, and remove.
Remove the roller.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele Complete C2 and is the answer not in the manual?

Miele Complete C2 Specifications

General IconGeneral
Power controlElectronic
Maximum input power800 W
Annual energy consumption30 kWh
TypeCylinder vacuum
Cleaning typeDry
Dust capacity4.5 L
Flexible hoseYes
Product colorRed
Tube materialStainless steel
Dust container typeDust bag
Proper useHome
Noise level77 dB
Cleaning surfacesCarpet, Hard floor
Vacuum air filteringMiele AirClean
Dirt separating methodFiltering
Cord length6.5 m
Vacuum brushes includedDusting brush
Weight and Dimensions IconWeight and Dimensions
Depth275 mm
Width590 mm
Height380 mm
Weight6000 g

Related product manuals