Problem solving guide
36
Problem Cause and remedy
flashes alternately
with in a cooking zone
display. The cooking
zone has switched off
automatically.
There has been no pan, or an unsuitable pan, on the
cooking zone for more than 3minutes.
Use pans that are suitable for induction (see
“Pans”) or switch off the cooking zone if it is no
longer needed.
The overheating protection mechanism has been ac-
tivated.
See “Overheating protection”.
TwinBooster level II has been activated on the linked
cooking zone.
appears in the cook-
ing zone display.
The overheating protection mechanism has been ac-
tivated.
See “Overheating protection”.
appears in the display
for several seconds
after a cooking zone
has been switched on.
The system lock has been activated.
You need to deactivate the system lock (see “Sys-
tem lock”).
appears in the display
for several seconds
after a cooking zone
has been switched on.
The cooking zone does
not heat up.
Demonstration mode is activated.
Turn the right-hand (outer) cooking zone control
twice briefly anti-clockwise to the point of resist-
ance then once again, holding it for approx.
3seconds.
To Next Page
Loading...
Need help?
General
