When using electrical appliances, basic safety precautions should always be
followed, including the following:
Read all instructions before installation or use of the coffee system.
Please read these instructions
carefully to prevent accidents and
machine damage.
This appliance is for household use
only. Use appliance only for its
intended use. Any other use could
be dangerous.
This appliance complies with current
safety requirements. Improper use of
the appliance can cause personal
injury and material damage.
The manufacturer cannot be held
responsible for damage caused by
improper use of the appliance.
Electrical safety
Before connecting the appliance to
the electrical supply make sure
that the voltage and frequency details
listed on the data plate correspond with
the household electrical supply. If in
doubt, consult a qualified technician.
The appliance must be properly
installed before operation to ensure
that no electrical components are
accessible. Ensure that power is not
supplied to the appliance while
installation, repairs or maintenance
work is performed.
Be certain your appliance is
properly installed and grounded by
a qualified technician. To guarantee the
electrical safety of this appliance,
continuity must exist between the
appliance and an effective grounding
system. It is imperative that this basic
safety requirement be met. If there is
any doubt, have the electrical system of
the house checked by a qualified
electrician. The manufacturer cannot be
held responsible for damages caused
by the lack or inadequacy of an
effective grounding system.
Do not use an extension cord to
connect the appliance to electricity.
Extension cords do not guarantee the
required safety of the appliance
(danger of overheating).
This appliance is not designed for
maritime use or for use in mobile
installations such as recreational
vehicles or aircraft. However, under
certain conditions it may be possible for
installation in these applications. Please
contact the Miele Technical Service
Department with specific requirements.
Before service or maintenance
work disconnect the power supply
by either removing the fuse, "tripping"
the circuit breaker or unplugging the
unit.
IMPORTANT SAFETY INSTRUCTIONS
5
To Next Page
Loading...
Need help?
General
