"F" messages
The message F 10 or F 17 appears in the display.
No water is dispensed.
–
The water tank is not inserted properly.
Take it out and reinsert correctly.
–
The water tank was not filled correctly
during the descaling process. Fill the
water tank up to the correct mark.
–
After fixing the fault, the machine turns
off then on again. Start the desired
preparation again.
–
If the message still appears contact
Technical Service.
The message F 73 shows or "Check brew unit" appears in the display.
The brew unit is clogged and cannot
reset to the correct position.
– Select "Clear".
– Take out and clean the brew unit. See
"Cleaning and Care - Brew unit".
– Reinsert the brew unit and close the
door.
– If the message still shows contact
Technical Service.
The message "Too much ground coffee" appears in the display.
If too much ground coffee passes
through the coffee chute the machine
is unable to process it so it can be
emptied into the waste container.
–
Select "OK".
The machine is now ready for use.
Frequently asked questions
52
To Next Page
Loading...
