. . . the fault message 10 or 17 appears.
Water has not been taken in.
^
The water container has not been correctly positioned
inside the machine. Remove the water container and push
it back in again, making sure it is positioned correctly.
^
This error message also appears if the water container was
not correctly filled for descaling. Fill the water container up
to the k mark.
^
After you have remedied the problem, switch the machine
off and then back on again after a short while. Select the
process you want again.
If this fault message still continues to appear in the display,
repeat the steps described above. If despite this, the fault
message still appears in the display, call the Miele Service
Department.
. . . the seal on the connection between the coffee outlet
and the brew unit is damaged and is leaking.
^ Replace it with the extra seal supplied.
^ Check the machine door. Over time the door can come out
of alignment and damage the seal. Align the door using the
hinges (see "Installation: Adjusting the door hinges").
. . . too much crema has formed and is overflowing above
the coffee spouts.
Some types of coffee will produce too much crema if the
coffee or espresso temperature is set to maximum and the
amount of coffee to be ground is set too high.
^
Set a lower temperature and reduce the amount of coffee
to be ground.
. . . the milk froth is "spitting".
Perhaps the system was not filled with water before the first
drink was made. Fill the system with water as described in
"Making coffee: Cappuccino and milk froth - Using for the first
time or after descaling".
Problem solving guide
74
To Next Page
Loading...
Need help?
General
