Choosing a language
The language for the commands in the display win-
dow can be selected before the machine is used for
the first time.
Turn the program selector counterclockwise to
“Program mode”.
The appliance can now be programmed and will
respond according to the symbols shown under
the buttons.
The following will appear in the display window:
Programming option “Language” will be high-
lighted with an asterisk.
Press ENTER to confirm this programming option.
The sub-menu is shown in the display window as
follows:
Press the e button until the desired language ap-
pears (deutsch, nederlands, portugues, espanol,
english, italiano or francais)
Press ENTER to save this setting, or
turn the program selector to “0ff” to cancel if a
mistake has been made.
This will bring you out of the sub-menu.
All commands in the display window will now ap-
pear in the selected language.
Programming the appliance
13
To Next Page
Loading...
