Cleaning and care
59
Press the latches on the left and
right-hand sides of the milk valve
holder and pull the holder forwards to
remove it.
Take the holder and silicone seal
apart.
Pull the stainless steel bolt upwards
and out.
Clean the individual components of
the milk valve in the dishwasher.
Tip: If there are any dry milk residues
on the front, soak the stainless steel
bolt in warm water and a little washing-
up liquid.
Fitting the milk valve
Insert the stainless steel bolt from
above.
Insert the silicone seal into the milk
valve holder.
Insert the holder and silicone seal
until they audibly click into place.
To Next Page
Loading...
