Cleaning and care
60
Connect together the angular
moulded hose and longer milk
pipework. Start by attaching the
moulded hose to the top of the
central spout. The black connecting
piece should be pointing to the rear.
Then, connect the bottom end of the
moulded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, turn the milk
pipework towards the back at the
connecting piece on the right-hand
side.
Attach the milk valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backwards until a proper fit is
achieved.
Push the left-hand bean container
and maintenance container back into
the coffee machine. Attach the
central spout’s stainless steel cover.
Close the appliance door.
To Next Page
Loading...
