Problem solving guide
75
Push the catches on the left and right
of the milk valve holder and pull the
holder forwards to remove.
Dismantle the holder and the silicone
seal.
Lift out the stainless steel stem.
Clean the individual parts of the milk
valve in the dishwasher.
Useful tip: If dried on milk residues are
located on the front side, soak the
stainless steel stem in warm water with
a little washing-up liquid before placing
it in the dishwasher.
Fitting the milk valve
Slide in the stainless steel stem from
above.
Fit the silicone seal in the milk valve
holder.
Fit the holder with the silicone seal
until it clicks into position.
To Next Page
Loading...
