Installation
30
Refit the grease filters.
For air extraction mode
If your ducting system does not have a
non-return flap, two are supplied with
the rangehood. One for 150mm and
one for 120mm ducting.
For 150mm ducting, fit the non-
return flap into the exhaust
connection.
For 120mm ducting, fit the
reducing collar supplied onto the
exhaust connection and then fit the
appropriate non-return flap onto the
reducing collar.
Secure the exhaust ducting to the
exhaust connection, e.g. with a hose
clip (available as an optional
accessory) on flexible ducting.
See "Connection for air extraction"
for further instructions on fitting the
ducting.
To Next Page
Loading...
