Resetting the charcoal filter
operating hours counter
The indicator lamp for the charcoal filter
control will light up after the cooker
hood has operated for the number of
hours set. The charcoal filters must be
replaced with new ones.
Afterwards, the charcoal filter operating
hours counter must be reset.
^ Press and hold the charcoal filter
control for about 3 seconds while the
fan is switched on.
The indicator lamp for the charcoal filter
control will go out.
Reading the charcoal filter operating
hours counter
To check the percentage of time set
already used:
^
Switch the fan on with the joystick.
^
Press and hold the charcoal filter
control.
One or several of the power level
indicator lamps will flash.
The number of flashing lamps shows
the percentage of the operating time
which has already been used up.
1 lamp = 25 %
2 lamps = 50 %
3 lamps = 75 %
4 lamps = 100 %
The number of operating hours used
remains in the memory, even when the
appliance is switched off or there is a
power cut.
Operation
19
To Next Page
Loading...
