Before using for the first time
25
To activate Con@ctivity 2.0 press the
control.
2 will light up constantly, 3 will flash on
and off.
After a few seconds 2 and 3 will light up
constantly, B will flash on and off.
The search for a radio frequency
connection will start.
Activating the cooktop
While the rangehood is searching for
a signal, start activating the cooktop.
For further details, see the cooktop
operating instructions.
When the cooktop registers that a
connection has been established, exit
activation on the cooktop.
Finishing activation on the
rangehood
When successfully connected B will go
out, and 2 and 3 will light up constantly.
Confirm activation with the run-on
control. All the indicator lights will
go out.
The Con@ctivity 2.0 function is now
ready for use.
If you do not confirm your selection
within 4 minutes, activation will not take
place.
You only need to carry out the
activation procedure once. If the
appliances are disconnected from the
electricity supply, for example during a
power cut, they will still remain
activated.
To Next Page
Loading...
