Replacing the grease filter
^
Remove the protective strip around
the edge of the grease filter.
Replace the grease filter.
^
To do this, pull the deflector plate out.
^
Turn the grease filter so that the red
plastic guides are at the front and
facing upwards.
^
Replace the grease filter in the front
of the deflector plate, press it
upwards and push it in together with
the deflector plate. It will slide onto
the fixing pins at the back. Finally,
push the grease filter back a little
more.
Set up for extraction mode
^
If the on-site ventilation system does
not have a non-return flap, then the
non-return flap supplied with the
appliance must be fitted in the
exhaust socket in the motor unit.
Depending on model, the non-return
flap may already be fitted.
^
When using C 150 mm ducting,
secure the exhaust connection
supplied to exhaust ducting with
hose clips.
Installation
30
To Next Page
Loading...
