Cleaning and care
22
Changing a halogen lamp
The halogen lights become very hot
during operation.
It can cause burns even after being
switched off for some time.
Allow them to cool down for a few
minutes before changing them.
Disconnect the rangehood from the
mains electrical supply before
replacing the lamp (see "Warning and
Safety instructions").
Remove the grease filters.
Turn the bolt anti-clockwise as far as
it will go. The halogen lamp will then
drop down towards you.
Turn the halogen lamp anti-clockwise
and pull it out.
Replace it with a new lamp of the
same type: GU/GZ 10, 230 V, 50W.
Refit the lamp by reversing the steps
shown above. Please observe
manufacturer's instructions.
Replace the grease filters.
To Next Page
Loading...
