Operation
18
Dimming/switching the
overhead lighting on/off
The overhead lighting can be switched
on and off and dimmed independently
of the fan.
Press the lighting button briefly to
switch it on or off.
The lighting will switch on at maximum
brightness.
Press and hold in the lighting button
. The brightness will gradually dim
until you release the button.
Press and hold in the lighting button
again to increase the brightness to
the level required and then release it.
Filter saturation indicator
The number of hours the hood has
been in operation is stored in appliance
memory.
The filter saturation indicators show
when the filters need to be cleaned or
changed by lighting up the grease filter
symbol or OdorFree Charcoal Filter
symbol . Additional information on
cleaning and changing the filters and
resetting the filter saturation counters
can be found under "Cleaning and
care."
Adjusting the filter saturation
indicator for the grease filter
You can set the filter saturation
indicator to suit your cooking habits.
The factory default setting is a cleaning
interval of 30 hours.
– Select a shorter time (20 hours) if you
often fry foods.
– We also recommend a shorter
cleaning interval if you only cook
occasionally. This will prevent grease
buildup from hardening and making
cleaning more difficult.
– Select a longer cleaning interval of 40
or 50 hours if you use very little fat
when cooking.
Press the On/Off button to turn off
the fan.
Press the delayed shut down button
and the grease filter button at
the same time.
The grease filter symbol and one of
the fan power level indicators will flash.
To Next Page
Loading...
