^
Loosen the bracket that holds the
appliance to the pallet.
,
Caution! The appliance is no
longer secured and may be
unstable.
^ From the rear of the appliance
carefully lift it from the pallet.
Once the appliance is on the ground it
can be wheeled around.
RemoteVision module
installation
(optional accessory)
Always disconnect the appliance
from the power supply when
performing installation, maintenance
or service work.
Install the RemoteVision module
before placing the appliance in its
installation niche.
Once connected the RemoteVision
module will increase the energy
consumption of the appliance.
The slot for the RemoteVision module is
located in the lower area of the back of
your appliance.
^
Unscrew the screws a on the cover
b and pull off the sticker c.
^
Remove the cover b.
^
Push the module into the slot until it
locks into place.
^
Connect the appliance to the power
supply and turn it on. After several
seconds the indicator light will come
on.
The indicator light will display different
colors one after the other; any control
light at the end indicates that the
module was correctly installed.
Installing the appliance
53
To Next Page
Loading...
Need help?
General
