Before using for the first time
The stainless steel surface of the
appliance is protected with a plastic
film, which protects it during shipping.
Do not remove this protective film until
the appliance has been completely
installed.
After removing the protective film clean
the exterior surface with the supplied
stainless steel agent. This will aid in
preventing resoiling.
^
Clean the inside of the appliance and
the accessories with a mild solution
of warm water and liquid dish soap.
Dry with a soft cloth.
If the appliance was transported to
the installation site horizontally,
leave the appliance standing
upright for approx. 8 hours before
connecting it to the electrical supply.
This is very important to ensure
correct functioning.
Turning the appliance On/Off
^
Open the appliance door.
^
Turn the appliance On/Off with the
main switch.
The main switch is located on the
right-side underneath the control panel.
Once on, the appliance begins cooling.
When the door is open, the interior
lights come on.
The access button will light in the
control panel.
The preset temperatures (factory
default settings) are reached after a few
hours. Do not put any food in the
appliance until the preset temperatures
are reached.
,
Turning off the appliance with
the main switch does not safely
isolate it from the power supply.
Before use
10
To Next Page
Loading...
Need help?
General
