Technical Information
10
G 1xxx/G 2xxx
Function Programming Display
Water quantity
normal/increased
Press the Delay Start
button 23x. The "Delay
Start" LED flashes 2x
slowly and 3x rapidly
intermittently. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse" LED is off or flashes.
The display shows p and a digit
alternately: p0 = Normal water
quantity (standard setting); p1 =
Increased water quantity. If
increased water quantity is
selected, approx. 16.7 fl.oz.
(500mL) more water is taken in
during each water intake cycle.
Soak activation/
deactivation
Press the Delay Start
button 24x. The "Delay
Start" LED flashes 2x
slowly and 4x rapidly
intermittently.
Press the Start/Stop
button as appropriate to
make the desired setting.
The "Rinse" LED is off or flashes.
The display shows p and a digit
alternately. Setting options: p0 =
Soak not activated; p1 = Soak
activated. If powder detergent is
used, approximately 1 teaspoon (5
grams) should be poured into
detergent chamber 1.
Pre-wash activation/
deactivation
Press the Delay Start
button 25x. The "Delay
Start" LED flashes 2x
slowly and 5x rapidly
intermittently. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse" LED is off or flashes.
The display shows p and a digit
alternately. Setting options: p0 =
Pre-wash not activated; p1 =
Pre-wash activated.
Second interim rinse
Press the Delay Start
button 26x. The "Delay
Start" LED flashes 2x
slowly and 6x rapidly
intermittently. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse" LED is off or flashes.
The display shows p and a digit
alternately. Setting options: p0 =
Standard setting; p1 = With second
interim rinse.
Activating/deactivating
improved drying
Press the Delay Start
button 27x. The "Delay
Start" LED flashes 2x
slowly and 7x rapidly
intermittently. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse" LED is off or flashes.
The display shows p and a digit
alternately. Setting options: p0 =
Normal drying time; p1 = Extended
drying time.
Appliance width setting
1
Press the Delay Start
button 35x. The "Delay
Start" LED flashes 3x
slowly and 5x rapidly
intermittently. Press the
Start/Stop button as
appropriate to make the
desired setting.
The "Rinse" LED is off or flashes.
The display shows p and a digit
alternately. Setting options: p0 =
24” (60cm); p1 = 18” (45cm).
To Next Page
Loading...
Need help?
General
