Miele G 1102 SCi - Problem solving guide; The Wash;Rinse, Drying and End indicator lights flash simultaneously

Problem Possible cause Remedy
The Wash/Rinse,
Drying and End
indicator lights flash
simultaneously.
There may be a technical
fault.
–
Clean the water inlet filter
and clean the drain pump
and non-return valve as
described in
"Maintenance". If this does
not resolve the problem,
–
switch the dishwasher off
with the On/Off button K.
After a few seconds:
–
Switch the dishwasher
back on.
–
Select the programme
required with the
programme selector
button.
– Press the Start/Stop
button.
If the programme sequence
indicator lights flash again,
there is a technical fault.
– Call the Service
Department.
The drain pump works
even when the door is
open.
The Waterproof system
has reacted.
–
Close the stopcock.
–
Call the Service
Department.
Problem solving guide
40