Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Open the door.
^
Switch the dishwasher off with the Off
button V.
^
Press the programme selector button
;? in, and whilst holding it in
switch the dishwasher on using the
On button U.
Keep the programme selector button
;? pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
;? 12 times briefly.
The Inlet/drain check light 2/2 will
give one long flash and two brief
flashes at intervals.
The upper right hand indicator shows
whether a setting other than the factory
default setting has been set.
–
If the upper right hand indicator is
flashing:
All settings are factory default
settings.
–
If the upper right hand indicator is
not lit up:
At least one setting has been altered
from the factory default setting.
^
If you want to reset the factory default
settings, press the programme
selector button ;? for at least one
second until the Inlet/drain check
light 2/2 comes on.
^ Press the programme selector button
;? briefly.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button V.
Operation
37
To Next Page
Loading...
