Miele G 2270 - Water Fill, Drain, and General Issues

The dishwasher does not fill/drain
Problem Possible cause Remedy
The In-operation
indicator is flashing
quickly.
The buzzer is
sounding.
The Inlet/Drain
indicator flashes
when the door is
open.
The stopcock is
closed.
–
Open the stopcock fully.
The dishwasher
stops during a
programme.
The In-operation
indicator is flashing
quickly.
The buzzer sounds.
The Inlet/Drain
indicator flashes
when the door is
open.
Fault code FXX
shows in the
Display.
Before rectifying the problem you
must:
– Switch the dishwasher off with the
Off button o.
Fault F12/F13:
Water inlet
restricted.
– Open the stopcock fully.
– Clean the water inlet filter (see
"Problem solving").
– The water pressure at the intake is
lower than 30 kPa (0.3 bar).
Seek professional advice.
Fault F11:
Water outlet is
restricted, water
remains in the
wash cabinet at
the end of a
programme.
– Clean the filter combination. See
"Cleaning and Care".
–
Clean the drain pump. See
"Problem solving".
–
Clean the non-return valve. See
"Problem solving".
–
Remove any kink in the drain hose.
Problem solving guide
48