Factory default
All settings can be reset to factory
default.
^
Open the door.
^
Turn the dishwasher off with the V
button.
^
Press and hold the Program button
and turn the dishwasher on
simultaneously using the K button.
Keep the Program button pressed for
at least four seconds until the lower
right program indicator lights up.
If it does not come on, start over.
^ Press the Program button briefly 12
times.
The "Intake/Drain" indicator flashes
once long and twice short.
The sequence of flashing by the upper
right program indicator shows whether
a setting has been set differently to the
default setting.
–
upper right program indicator
flashes:
all values are set to the default
settings.
–
upper right program indicator is off:
at least one setting has been
changed.
^
To reset the dishwasher to factory
default press the "Program" button
(for at least one second) until the
"Intake/Drain" indicator lights up.
^ Now press the Program button
briefly.
The setting is saved immediately.
^ Turn the dishwasher off with the V
button.
Additional options
37
To Next Page
Loading...
