Refill salt message
^ When the "Salt" indicator light comes
on, refill the salt after the program
has finished.
After the container has been filled, the
"Salt" indicator light can remain on for a
short time. It will go out once the
reactivation process is complete.
The "Salt" indicator light is turned off if
you have programmed the dishwasher
to a water hardness below 4 °d
(4 gr/gal).
,
Immediately after each refill, run
the "Express" program without a load
(no "Turbo" function if available).
This will remove any traces of salt
from inside the wash cabinet.
Before using for the first time
15
To Next Page
