,
Repairs should only be carried out by a qualified and trained person in
accordance with local and national safety regulations. Unauthorized repairs
could cause personal injury or machine damage.
Technical faults
Problem Possible fault Solution
After turning on the
dishwasher with the K
button, the Start/Stop
indicator light does not
flash.
The dishwasher is not
plugged in.
Insert the plug.
The circuit breaker has
tripped.
Reset the circuit breaker.
(See data plate for the
correct fuse rating).
The dishwasher stops
during a program.
The circuit breaker has
tripped.
– Reset the circuit
breaker (see data plate
for the correct fuse
rating).
– If the circuit breaker
trips again, contact
Miele.
The program sequence
indicators Main wash,
Drying and End all flash
simultaneously.
The time display shows
fault FXX.
There may be a technical
fault.
– Press the K button to
turn the dishwasher off.
After a few seconds:
– Turn the dishwasher
on.
– Use the Program
button to select the
desired program.
– Press the Start/Stop
button.
If the program sequence
indicators flash again,
there is a technical fault.?
– Contact Miele.
In addition, the drain
pump may run even
when the door is open.
Fault F70:
The waterproof system
reports a fault.
– Close the water tap.
– Contact Miele.
Frequently asked questions
45
To Next Page
Loading...
