Miele G 5266 - Buzzers

Program options
53
Buzzers
A sequence of buzzer tones will sound
at the end of the program or if there is a
fault.
The buzzers at the end of a program
and the alarm tone in the event of a
fault will sound four times at intervals
with a short pause between each set.
The buzzers are switched off as
standard.
You can switch on the buzzers that
sound at the end of a program if you
wish. The alarm tone that sounds in the
event of a fault is always switched on.
 Open the door.
 Turn the dishwasher off with the
button, if it is turned on.
 Press the button in and, while
holding it in, turn the dishwasher on
using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
 Press the Program button 4times.
The top left program indicator light will
flash rapidly 4times at intervals.
The flashing sequence in the time
display indicates whether the buzzers at
the end of the program are activated or
deactivated:
-  : buzzers are activated
-  : buzzers are deactivated
 Press the button to change the
setting.
The setting is now saved.
 Turn the dishwasher off with the
button.