Frequently Asked Questions
80
Water intake fault
Problem Possible cause and solution
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Open water supply The water supply is turned off.
Open the water supply valve all the way.
Intake Before remedying the fault:
Turn off the dishwasher.
Water-intake fault.
Open the water-supply faucet all the way and start
the program again.
Clean the water-intake filter (see “Cleaning the wa-
ter-intake filter” under “Cleaning and care”).
The water-connection pressure is lower than 7.25
psi (50kPa).
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Water drainage” under “Installa-
tion”).
To Next Page
