Program chart
Program When to use Detergent
containing
chlorine
1)
chlorine
free
2)
Compart-
ment I
(Pre
wash)
Compart-
ment II
(Main
wash)
Compart-
ment II
(Main
wash)
Program
NORMAL
55 °C/130 °F
This program is for normal everyday loads. 20 % 80% 100 %
NORMAL
65 °C/150 °F
Same as NORMAL 55 °C/130 °F, but at a
higher temperature. Use for stubborn
dried on particles.
20 % 80 % 100 %
INTENSIVE
55 °C/130 °F
Contains an additional pre-wash cycle.
Use for heavily soiled dishes.
20 % 80 % 100 %
INTENSIVE
65 °C/150 °F
Same as INTENSIVE 55 °C/130 °F, but at a
higher temperature. Use for stubborn dried
on particles and lightly soiled pots and
pans.
20 % 80 % 100 %
Special programs
ECONOMY
55 °C/130 °F
For a half sized load, or for a full load with
very light soiling (e.g. coffee cups). 50 %
3)
50 %
3)
RINSE & HOLD
For rinsing dishes if a complete program is
not yet needed.
The dispensing ratio will depend on the type of detergent being used:
1) Use this ratio for:
– detergents which contain phosphates and chlorine.
Divide the total amount, as shown, between compartment I and compartment II.
2) Use this ratio for:
– detergent which is chlorine and phosphate free.
– detergent which is chlorine free but contains phosphates.
In this instance the whole amount is placed in compartment II.
3) Use half of the normal amount of detergent.
Program chart
28
To Next Page
