Miele G 6860 - Water Inlet Fault

Problem solving guide
73
Water inlet fault
Problem Cause and remedy
The In-operation indic-
ator is flashing quickly.
The buzzer is sounding.
One of the following
faults is shown in the
display:
Open stopcock The stopcock is closed.
 Open the stopcock fully.
Water intake Before rectifying the problem:
 Switch the dishwasher off with the  button.
The water intake is restricted.
 Open the stopcock fully and start the programme
again.
 Clean the water inlet filter (see "Maintenance").
 The water pressure at the intake is lower than
50kPa (0.5bar).
Seek professional advice.
The following message
appears in the display
during the SolarSave pro-
gramme:
 Intake temp. low
The intake water has not reached the required tem-
perature of 45°C (see "Plumbing, Connection to the
water supply").
 Start the programme again.
 If the fault message appears again, select a differ-
ent programme.