Miele G 690 - Hardness Level 650 - 1260 Mg;L (36 - 70 °D German Scale)

Hardness level 650 - 1260 mg/l
(36 - 70 °d German scale)
Switch off the dishwasher.
Press and hold in the "+" and
"START/Stop" buttons, and
at the
same time switch on the dishwasher
with the "ON/OFF " button.
"P" and two figures appear in the
time display.
Press the "UNIVERSAL 55 °" pro-
gramme button.
A figure appears in the display corre-
sponding to the water hardness level
already set, e.g. "22" – the water sof-
tener is set to a water hardness level
of 400 mg/l (22 °d German scale).
Keep pressing the "Top Solo" button
until "36" appears in the display.
Once the figure "36" is reached the
counter returns to "1".
Press the “START/Stop” button.
“SP” appears in the time display.
Press the “START/Stop” button again.
All the control lights next to the pro-
gramme selection buttons and the deci-
mal point in the time display light up.
The change to water hardness recogni-
tion is now stored in memory.
In addition the water hardness selector
in the wash cabinet must be set accord-
ing to the chart.
°d mgl/l °f
Value for
program-
ming
Water-
hardness
selector
(Settings)
36-47 650-850 65-85 36 4
48-65 860-1170 86-117 36 5
66-70 1190-1260 119-126 36 6 *)
*) factory setting
Example:
Water hardness is 920 mg/l (52 °d).
The water hardness selector must be
turned to setting 5 (48 - 65 °d).
Switch the dishwasher off.
Use a screwdriver to remove the lid
of the water hardness level selector
in the wash cabinet.
Check that the selector is set to set-
ting 6 (factory setting). If not, use a
flat blade screwdriver or a coin to
turn the selector until it clicks on set-
ting 6.
For technical reasons do not set the
selector to setting 1 - 3.
Water softener
16