The wash cycle is cancelled before
the end and the “Water outlet” check
light flashes
– The drain hose is kinked.
– The drain pump is blocked – see
“Cleaning and care”.
– Foreign bodies are obstructing the
non-return valve - see "Cleaning and
care".
Before removing the obstruction:
Press the START/Stop button for at
least one second.
All indicator lights next to the pro-
gramme selector buttons light up.
Switch off the dishwasher with the
ON / OFF switch.
The “Spray arm” check light flashes
– The middle spray arm is obstructed
by crockery.
Open the dishwasher door and
remove the obstruction.
– The spray arm jets are blocked - see
"Cleaning and care".
Before removing the obstruction:
Press the START/Stop button for at
least one second.
All indicator lights next to the pro-
gramme selector buttons light up.
Switch off the dishwasher with the
ON/OFF switch.
Shortly after starting a programme
the “Water inlet”check light
flashes
– The stopcock is shut.
Open the stopcock.
The dishwasher should continue
the programme.
If the programme does not continue:
Press the START/Stop button for at
least one second.
All indicator lights next to the pro-
gramme selector buttons light up.
Switch off the dishwasher with the
ON/OFF switch.
Start the programme again - see
"Switching on and off".
– Too little water flows into the wash
cabinet. This may be due to insuffi-
cient water pressure at the intake
(flow pressure at the water inlet).
– The filter in the screw connection of
the valve on the water inlet hose is
blocked - see "Cleaning and care".
Before removing the obstruction:
Press the START/Stop button for at
least one second.
All indicator lights next to the pro-
gramme selector buttons light up.
Switch off the dishwasher with the
ON/OFF switch.
Problem solving guide
50
To Next Page
Loading...
