Problem Possible cause Remedy
The indicator light
"Water inlet" lights up
and flashes alternately
The stopcock is closed. Open the stopcock fully.
The water inlet filter is
blocked.
Before rectifying the prob
-
lem you must:
–
Press the "Start/Stop"
button for at least one
second.
All the programme button
indicator lights will light up.
–
Switch the dishwasher
off using the "On/Off"
button.
then:
– Clean the water inlet fil-
ter, see "Solving prob-
lems".
The Waterproof system
has reacted.
Call the Miele Service De-
partment.
The indicator light
"Water inlet" lights up
during the "Energy
save" programme.
The intake water has not
reached the required tem-
perature of 45 °C, the hot
water system may be over-
loaded (see "Programme
selection").
– Start the programme
again.
– If the indicator light co-
mes on again select a
different programme.
Problem solving guide
47
To Next Page
Loading...
