Miele G 7154 - Water Intake Fault

Problem solving guide
76
Water intake fault
Problem Possible cause and remedy
The optical in-operation
indicator light is
flashing quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Turn on tap The tap is turned off.
 Turn on the tap fully.
Water intake Before rectifying the problem, you must:
 Switch the dishwasher off.
Water intake is restricted.
 Turn on the tap fully and start the programme
again.
 Clean the filter in the water inlet (see “Cleaning
and care – Cleaning the water inlet filter”).
 The water connection pressure is lower than
50kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Installation – Drainage”).
Fault F18 A technical fault has occurred.
 Switch the dishwasher off.
 Turn off the tap.
 Call Miele.