Frequently asked questions
86
Water intake fault
Problem Possible cause and solution
The in-operation indica-
tor light is flashing
quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:
Open water supply The water supply is turned off.
Open the shut-off valve all the way.
Intake Before remedying the fault:
Turn off the dishwasher.
Water-intake fault.
Open the shut-off valve all the way and start the
program again.
Clean the water-intake filter (see “Cleaning the wa-
ter-intake filter” under “Cleaning and care”).
The water-connection pressure is lower than
7.25psi (50kPa).
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Water drainage” under “Installa-
tion”).
Fault F18 A technical fault has occurred.
Turn off the dishwasher.
Close the shut-off valve.
Contact Miele Customer Service.
To Next Page
Loading...
