Installation
*INSTALLATION*
113
Water inlet
Risk to health due to wash water.
Water in the dishwasher must not be
used as drinking water.
Do not drink any water from the dish-
washer.
Risk to health and risk of dam-
age due to contaminated incoming
water.
The quality of the incoming water
must correspond to the drinking wa-
ter specification of the country in
which the dishwasher is being oper-
ated.
Connect the dishwasher to a drinking
water supply.
The dishwasher may be connected to
cold or hot water (up to max.
140°F/60°C) supplies.
We recommend connecting to a cold
water supply to reduce energy con-
sumption.
If energy-saving water-heating sources,
such as solar energy circulation sys-
tems, are used, we recommend con-
necting to the hot water. This saves
both time and electrical energy costs.
Hot water is used in all programs.
The EnergySaverprogram (if available)
requires a hot water connection of be-
tween a minimum of 113°F/45°C and a
maximum of 140°F/60°C (intake tem-
perature).
The higher the water intake tempera-
ture, the better the cleaning and drying
results.
The water inlet hose is approx.
5ft/1.5m long. The slightly transparent
corrugated hose around the water inlet
hose provides protection during trans-
portation and can be removed if neces-
sary. However, if desired the corrugated
hose can be left in place to provide ad-
ditional protection during daily use.
To Next Page
Loading...
Need help?
General
