Changing a programme
Provided the “Start” button has not yet
been pressed, a wrongly selected pro-
gramme may be changed as described
below, (if it has been pressed see “Can-
celling a programme”):
Turn the programme selector to the
required function.
Select additional function 3
(DRYING) again if required (see
“Selecting an additional function”).
Press the “Start” 6 button.
Selecting an additional function
The following additional function can
be selected:
3 DRYING
“Drying” may be selected as an
additional function as soon as a
programme has been selected (ex-
cept with D “COLD RINSE” and 6
“DRAIN”). The drying phase oper-
ates with pulsed heating for
10 minutes. The total running time
of the programme is lengthened
accordingly.
Programme sequence indicator
The indicator light for the
active pro-
gramme stage lights up during the pro-
gramme.
k Reactivation
I Pre-rinse
l Main wash
m / H Interim rinse / Final rinse
c Drying (additional function)
Programme end
The programme has ended when no
more programme sequence indicators
are lit up and the “Start” indicator light
6 has gone out. An “0” is shown in the
middle of the display field.
Use the 4 button to see how long a
programme has to run or to see the ac-
tual temperature.
Switching off
Press in and release the I-0 button.
Note:
As the machine is fitted with an electric
door lock, the door can only be opened
if the I-0 button is pressed in (see
“Opening and closing the door”).
Switching the machine on and off
31
To Next Page
