5. Altering the wash temperature
and/or the temperature holding time
in the “Main wash” and “Final rinse”
programme stages
In the event of a service call-out, as-
sist the service technician by making
a note of any change to the wash
temperature and / or the temperature
holding time in the “Programme
chart”.
Factory settings for the
main wash tem-
perature and temperature holding
times and for the
final rinse tempera-
ture and its holding time are given in
the programme chart.
The main wash and final rinse tempera-
tures can be set from 30°C - 70°C and
the temperature holding time from 1 to
10 minutes.
Turn the programme selector to the
f “STOP” position (the programm-
ing level is displayed only in this
switch position).
Switch off the machine.
Press 4 and 6 at the same time,
hold them in and whilst doing so
switch the machine on with the I-0
button.
The current programme status “P...”
appears in the display.
The p / 6 indicator light comes on.
“Main wash” temperature:
Press 3 three times, “E03” (pro-
gramming level 3) appears in the dis-
play.
Turn the programme selector to the
programme which needs to be
changed. The actual value appears
in the display after °C.
Press 4 or hold it in, until the re-
quired value appears in the display.
“Main wash” temperature holding
time:
Turn the programme selector to the
f “STOP” position (the programm-
ing level is only displayed in this
switch position).
Press 3 again, “E04” (programm-
ing level 4) appears in the display.
Then:
Turn the programme selector back
to the programme which needs to be
changed. The actual value appears
in the display after min.
Press 4 until the required value ap-
pears in the display.
“Final rinse” temperature:
Turn the programme selector to the
f “STOP” position (the programm-
ing level is displayed only in this
switch position).
Press 3 again, “E05” (programm-
ing level 5) appears in the display.
Then:
Programming special functions
36
To Next Page
