DOS 3 (neutralizer)
Setting the neutralizer dosage
Set dosage concentration according to the neutralizer manufacturer's
recommendations.
Step Display / Result
^
Press the 0 button until E02 appears in
the display.
E02
^
Turn the program selector to "Intensive". The programmed dosage
concentration appears in the
display, e.g., 0.10 = 0.10 %
^ Press and hold the ß button until the
required value appears in the display,
e.g., 0.2.
0.20 The dosage concentration is
now set.
Dosage concentration setting:
Priming the dosage system
The dosage system does not need to be primed (cleared of air) unless:
– the dosage concentration is being set for the first time,
– the neutralizer container was inadvertently completely emptied .
Step Display / Result
^
Press the 0 button until E02 appears in
the display.
E02
^
Turn the program selector to "Universal".
d§3
^
Press the ß button.
The dosage system will be primed
automatically. Priming is complete
when 0 appears in the display.
^
Exit the programming mode.
Start "Rinse" program.
This will rinse away any agents that
entered the wash cabinet during
priming.
Programming functions
38
To Next Page
Loading...
